Atlantic SOLIUS Instrucciones De Instalacion Y De Uso página 8

The device you have just purchased was submitted to many tests and checks ensuring its quality.We thank you for your
choice and trust.We hope you will be fully satisfied.
Appliances with this symbol must not be scrapped with normal household rubbish but be collected
separately and recycled.
When these products come to the end of their useful life, they must be collected and recycled in accor-
dance with the local regulations and bylaws.
Keep these instructions even once you have installed your heater.
Warning
- Please ensure that children do not lean on the device or play close to it when it is operating : its surface may
be hot enough to cause burns to their skin in some circumstances, particularly because their reflexes may not
yet have been acquired or aur slower than those of an adult. If there is any risk, fit a protective grill in front of
the device.
- This device is not intended for use by persons (including children) with physical, sensory or mental disability, or
by persons lacking experience or knowledge, unless they have received from a person in charge of their safety
adequate supervision or preliminary instructions on how to use the device.
- Care must be taken at all times to keep children from playing with the device.
- Do not obstruct the grills, even partially (either on the front of the device or underneath it): otherwise the device
may overheat.
- If the supply cord is damaged, it must be replaced by a service agentor similarly qualified person in order to
avoid a hazard (applies to units fitted with a supply cord and plug).
- Units fitted with a three core supply cord (brown, blue and black), must be directly connected to hard wiring by
a licensed electrician.
- All work on the interior of the device must be carried out by a licensed electrician.
Preparing the installation of the panel heater
1/
Installation guidelines
- This device was designed to be installed in residential premises. In any other case, please call your distributor.
- Installation must comply with the standards currently enforced in the country of use.
- The panel heater must be supplied with 230V single-phase 50Hz.
- In damp areas such as bathrooms and kitchens, you must install the connection box at least 25cm above the floor.
Keep the panel heater away from any draughts that may interfere with its operation (e.g.: under a
centrally controlled fan, etc ...).
Do not install the heater under a fixed socket.
The panel heater is fitted with a detection system, whose sensor is located on the front of the appliance.
Volume 1
No electrical appliance
Volume 2
Class II IPX24 electrical appliance
Volume 3
Class II electrical appliance
Comply with the minimum distances from any furniture units when positioning the appliance
We strongly advise against installing vertical machines above an altitude of 1000m
(risk of faulty operation).
Installing a machine at altitude causes an increase in air output temperature
(of the order of 10°C per 1000m above sea level).
Installation
It is forbidden to install a vertical machine horizontally or vice versa.
Do not use the device in mobile, on feets or on casters.
8