Troubleshooting Guide - Atlantic SOLCC2 Manual Del Producto

Preset Light Changing Modes
Mode Selection
• To switch to the Color Wheel: hold the A button for two seconds and the light will return to
the last color displayed while in the Color Wheel mode. Run your finger around the color
wheel to select a new color.
• To switch to the Preset Light Changing Modes: hold the A button for two seconds, and the
light will return to the last preset mode displayed while in the Light Changing Modes. Press
the I and J button to switch between the different preset modes.
Changing the Brightness and Speed
In all modes, you can use the E and F keys to change the brightness of the light. In all
modes, you can use the G and H keys to change the speed of the light transitions. There are
10 levels for each.
Synchronizing the Remote to the Control Unit
If the remote control stops working properly, please install fresh batteries. If problems persist, the
remote may need to be re-synced to the control module.
Follow the instructions below to re-sync the remote control.
1. Unplug the transformer.
2. Hold the E button down (The red indicator lamp on the remote will be lit).
3. While still holding the E button down, plug in the transformer. The lights will start blinking.
• If the SOL Lights blink white three times and stops, the remote and control unit
are synchronized.
• If the SOL Lights blink white six or more times, it is clearing all codes. Repeat steps 1-3.
Warranty
All Atlantic SOL Color Changing Lighting carries a five-year limited warranty.
All SOL Wiring Components carry a five-year limited warranty.
Atlantic SOLTRANS88 carries a one-year limited warranty.
This limited warranty is extended solely to the original purchaser commencing from the date
on the original purchase receipt and is void if any of the following apply:
• The cord has been cut or altered between the light body and the control module.
• The light body / LED components have been misused or abused.
• The light body / LED components have been disassembled or modified other than as
described in this manual.
• The control module and/or remote control have not been adequately protected
from moisture.
This warranty excludes labor / cost of labor for removal or installation of any product.

Troubleshooting Guide

Always turn off power before inspecting the Color Changing Lights. Failure to observe this
precaution can result in a serious accident.
Before ordering repairs, carefully read through this instruction booklet. If the problem persists,
contact your dealer.
8