Storage; Troubleshooting - Beem Ceramicut Manual De Instrucciones

EN
If you do not intend to use the appliance for a longer period of time, clean it as described
in the section Cleaning and care (page 20).
Set the slicing thickness to the smallest gap to protect the slicer.
‹
Store the appliance and all accessory parts at a dry, clean and frost-free location,
‹
which is protected against direct sunlight.
The following table helps in localising and remedying minor faults:
fault
Motor does not start run-
ning.
The automatic circuit
breaker in the fuse box
trips.
Slicing result is not clean.
NOTE
► If you cannot resolve the problem with the steps described above, please contact
customer service.
BEEM - Elements of Lifestyle

Storage

Troubleshooting

Possible cause
Plug not inserted into
socket.
Automatic circuit breaker in
fuse box tripped.
Too many appliances con-
nected to the same power
circuit.
No fault detected.
Food tray does not slide
properly.
Slicer blade is blunt.
Ceramicut
Remedy
Insert plug.
Switch on the automatic
circuit breaker again.
Reduce the number of appli-
ances on the power circuit.
Contact customer service.
Clean the food tray.
Replace slicer blade.
21