Dometic WAECO PerfectView CAM33C Instrucciones De Montaje Y Uso página 42

_CAM33.book Seite 42 Freitag, 20. Mai 2011 11:40 11
Fitting the camera
If you want to screw on the camera with self-tapping screws (fig. i,
page 9)
A
NOTICE!
Self-tapping screws may only be fastened to steel metal with a min-
imum thickness of 1.5 mm.
➤ Drill 4 mm diameter holes at the points you just marked.
➤ Deburr all drill holes and apply rust-protection.
➤ Stick the double-sided adhesive insulation (fig. 8 3, page 5) to the as-
sembly side of the bracket.
The insulation plate serves as a seal and protects the paint.
➤ Screw the camera bracket on with the 5 x 25 mm self-tapping screws.
If you would like to attach the camera with threaded screws fitted
through the construction (fig. j, page 9)
A
NOTICE!
When tightening the nuts, make sure that they cannot be pulled
through the construction.
You may have to use bigger washers or plates.
➤ Drill 5.5 mm diameter holes at the points you just marked.
➤ Deburr all drill holes and apply rust-protection.
➤ Stick the double-sided adhesive insulation (fig. 8 3, page 5) to the as-
sembly side of the bracket.
The insulation plate serves as a seal and protects the paint.
➤ Screw the camera holder on with the M5 x 20 mm threaded screws.
Depending on the thickness of the construction, you may require longer
threaded screws.
Creating a through-hole for the camera connection cable (fig. k,
page 9)
I
NOTE
If possible, use available openings – such as ventilation grilles – to
feed the connection cables through. If there are no existing open-
ings, you must drill a hole with a 16 mm diameter.
42
PerfectView CAM33
EN