Connecting The Camera - Dometic WAECO PerfectView CAM33C Instrucciones De Montaje Y Uso

_CAM33.book Seite 44 Freitag, 20. Mai 2011 11:40 11
Fitting the camera
I
NOTE
Do not tighten the four M4 x 10 mm screws until you have aligned
the camera (see chapter "Checking the function and setting the
camera" on page 45).
To do this you must first install and connect a monitor.
7.3

Connecting the camera

I
NOTE
 Lay the camera cable so that should you need to remove the
camera, you can access the plug connection between the
camera and the extension cable easily. This considerably
eases dismantling work.
 To minimise corrosion in the plug, apply a small amount of
grease – such as pin grease – inside the plug.
➤ Guide the camera cable into the vehicle interior.
➤ Insert the plug of the camera cable into the socket of the extension cable.
➤ Screw on the plug connections of the connecting cables to protect against
water penetration (fig. c, page 7).
7.4 Connecting the RV-33-ADAPT switchbox
(only CAM33C, CAM33C1) (fig. p, page 10)
The switchbox is supplied ready for installation.
➤ Fasten the switchbox at a suitable point.
➤ Connect the control box electrically as follows:
– Connect the camera inputs on the monitor to the "V1" and "V2" con-
nections.
– Connect the system cable from the camera to the "TWIN" connection.
The camera is switched on and off in reverse gear or using the camera se-
lection button on the monitor.
44
PerfectView CAM33
EN