Mounting The Gas Detector; Connecting The Gas Detector - Waeco MagicSafe MSG150 Instrucciones De Montaje Y D’uSo

MSG-150.book Seite 22 Donnerstag, 30. Oktober 2008 5:03 17

Connecting the gas detector

7.2

Mounting the gas detector

Note the following information when selecting a location to mount the gas detector:
Note the length of the cable.
The gas detector should be mounted in the vicinity of the sleeping area at the height
of the mattress.
➤
Select a suitable installation location.
Caution!
Before making any drill holes, ensure that no electrical cables or other parts of
the vehicle can be damaged by drilling.
➤
Hold the mounting panel on the chosen location and mark the two drill holes (5,
page 5).
➤
Screw the mounting panel tight with the two screws (6, page 5).
➤
Insert the gas detector on the mounting panel (7, page 5).
➤
Insert the plug of the gas detector in the socket of your 12/24 V DC voltage supply.
✓ The green LED on the gas detector (8 1, page 5) flashes for approx. 10 min. The
sensor is then brought to the operating temperature.
When the green LED glows constantly, the gas detector is ready for operation.
8 Connecting the gas detector
8.1 As a single device
If you use the MSG-150 as a single device, you can either
Switch it on with the 12/24 V plug.
Switch it on with the RV-AMP-SW additional switch (accessory), if there is no 12/24 V
socket in the sleeping area.
Connecting the MSG-150 with a 12/24 V plug
➤
Insert the 12/24 V plug into a socket with a constant 12/24 V supply.
This socket should be connected to the battery.
✓
An acoustic signal sounds and the green LED (8 1, page 5) flashes for approx 10
minutes.
During this time the MSG-150 conducts a system test and the sensor is brought to
operating temperature.
22
MagicSafe MSG150