Working Instructions - Bosch DL 0 607 460 001 Manual Del Usuario

DL_bu_3609929393_t.fm5 Seite 11 Donnerstag, 18. Mai 2000 12:29 12
Type of Clutch
The machines have torque-dependent
ratcheting clutches that can be
adjusted over a wide range.
respond when the adjusted torque is
reached.
Type 0 607 460 001
Lever Start with Ratchet Clutch
Switching on: Press the lever 9.
When the torque setting for the
screwing operation is reached, the
screwdriver disengages until the
lever 9 is released.
Switching off: Release lever 9.
When the lever 9 is prematurely released, the
torque setting will not be reached.
Type 0 607 460 401
Switch Start with Ratcheting Clutch
Switching on: Press the on/off switch 12.
When the torque setting for the
screwing operation is reached, the
screwdriver ratchets until the on/off
switch 12 is released.
Switching off: Release the on/off switch 12.
When the on/off switch 12 is prematurely
released, the torque setting will not be
reached.

Working Instructions

Before performing any work on the machine
itself, disconnect the air supply.
Stick the tool inserts into the tool holder 1 until the
engaging of the detent is felt.
Setting the Torque
The desired tightening torque is set by turning the
collar 2.
Turning in the clockwise direction results in a higher
torque, in the counter clockwise direction, a lower
toque.
The collar 2 has a detent each quarter of a turn.
Caution!
For soft bolting actions, the clutch no longer
ratchets even for low torque settings.
After the adjustment
Adapt the torque by means of trial boltings for the
specific bolting action (hard, middle, soft). Check the
They torque with an electronic torque measuring instrument
or a torque wrench.
For higher torques, a correspondingly greater
counter force is necessary.
With a clamping device in the area 3, this counter
force can more easily be counteracted.
Machines that are operated with a torque of > 4 Nm
(or > 7 Nm for machines with pistol grip) are to be
used with a clamping device or an auxiliary handle.
Take care that the auxiliary handle or the clamping
device holds the unit in a firm and secure manner.
Reversing Rotational Direction
Type 0 607 460 001
Right rotation: Right/Left rotation button 4
pressed.
Left rotation: Right/Left rotation button 4 pressed.
By turning the right/left rotation button,
the position is locked.
Type 0 607 460 401
Right rotation: Set the right/left rotation switch 13 to
the right.
Left rotation: Set the right/left rotation switch 13 to
the left.
Extraction of the Exhaust Air
Only type 0 607 460 001
Slide the exhaust air hose 6
hose 7. Mount the air supply hose 7 onto the hose
connection piece 8
hose 6 to the housing.
Or remove hose connection piece 8 and attach the
exhaust air set (separate) to the connection piece on
the machine. Screw the hose connection piece 8
onto the connection piece.
exhaust air set (separate) can be removed and an air
hose to exhaust equipment mounted instead.
Advantages:
– Noise reduction
– No contamination of the working area by stirred
up dust
– Exhaust air led away.
not
over the air supply
and attach the exhaust air
The silencer on the
11