Alcohol O2 Installation And Calibration; Harness Connection - FuelTech ALCOHOL-O2 Manual De Instalación Y Especificaciones Técnicas

Alcohol - O2

5. Alcohol O2 installation and calibration

The Alcohol O2 has a sealed AMP connector, where you will find all the wires
EN
of sensors, feed, analog outputs and CAN.
See the following wiring diagram for details on the connections
When Alcohol O2 is connected through CAN network, analog output is
disabled - stays in 5V.

5.1 Harness connection

Wire color
*** Nano
Adapter
Blue
Yellow
White
Black/
White
Gray
Brown
White/Blue
White/Red
Black
Gray
Brown
Red/White
6
Pin
Unterminated
harness
Blue 3
Yellow 4
White 5
8 and
Black/White
9
Gray 10
Brown 11
Yellow/Red 12
White/Red 13
14 and
Black
15
Gray 16
Brown 17
Yellow/Red 18
Function
O2 #2 (right) H+ O2 #2 (right)
O2 #2 (right) H- O2 #2 (right)
O2 #2 (right) IP+ O2 #2 (right)
Engine ground (head/block). Connect
Power
to chassis or engine head/block. Do
ground input
not connect it to the battery negative.
O2 #2 (right) VS+ O2 #2 (right)
O2 #2 (right) VS- O2 #2 (right)
O2 #2 (right)
0-5V analog output O2 #2 (right)
analog output
CAN FT CAN HI
Connected directly to the battery.
Battery's
Do not connect this wire to the
negative
chassis, engine block or head.
input
VS+ O2 #1 (left)
O2 #1 (left)
O2 #1 (left) VS- O2 #1 (left)
O2 #1 (left)
0-5V analog output O2 #2 (left)
analog output
Information