Icemaker Installation T (Im4D Only) - GE IM4D Manual Del Propietário

ICEMAKER INSTALLATION INSTRUCTIONS T - IM4D ONLY
BEFORE YOU BEGIN
Read these instructions completely and carefully.
WARNING
To reduce the risk of
electric shock or injury during installation,
you must first unplug the refrigerator
before proceeding. Failure to follow
these instructions can result in electrical
shock.
TOOLS YOU WILL NEED
Flat blade and Phillips
screwdrivers
PREPARE FOR INSTALLATION
1
by pulling it out to the
stop position and lifting it
up and out.
NOTE: After removing
the basket, push the
extension arms back into
the freezer compartment.
pulling it straight out.
some models) by lifting it
and rotating its bottom to
the right.
remove the two small
white plug buttons
screws are present
instead of plugs,
leave them in place.)
the large white plug
from the rear freezer
wall.
screwdriver.
10
Installation Instructions
Pliers Sharp knife
or leave screws in place
plug button
Outlet
cover
SET POWER SWITCH TO OFF
2
Set the icemaker power switch to OFF
the power switch in the OFF position until the
refrigerator is connected to the water supply to
prevent premature operation.
Power
Switch
INSTALL THE MOUNTING
3
SCREWS
Skip to Step 4 if screws are already in place in
the freezer side wall.
Phillips head screws
from the kit in the holes in
the side wall. The screw
heads should extend about
wall.
INSTALL THE ICEMAKER
4
FILL CUP
that came with your unit into the icemaker as
49-60698-4