GE IM4D Manual Del Propietário página 12

Ocultar thumbs Ver también para IM4D:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

WATER VALVE INSTALLATION INSTRUCTIONS U V OR W
label on the back of the refrigerator -
BEFORE YOU BEGIN
Read these instructions completely and carefully.
WARNING
To reduce the risk of
electric shock or injury during installation,
you must first unplug the refrigerator
before proceeding. Failure to follow
these instructions can result in electrical
shock.
TOOLS YOU WILL NEED
Flat blade and Phillips
screwdrivers
REMOVE THE COVER
1
attach the cover to the back of the refrigerator
case.
Be sure to save the screws as the access
cover must be reinstalled later to ensure your
refrigerator will function properly.
WARNING
To reduce the risk of death or
electric shock, you must follow these
instructions:
Unplug the refrigerator before removing any
panels.
Do not damage any wiring while the panel is
removed.
Replace all parts and panels before plugging
the refrigerator back in.
12
Installation Instructions
V or W . For letter T , go to page 14 for instructions.
Sharp knife
Pliers
ATTACH THE WATER VALVE
2
connector plug.
Plug the female
connector
the male terminals
on the water valve
can go on either
terminal.
valve to the
cabinet by driving
the hex-head
screw
kit into the hole in
the cabinet leg.
CAUTION
Some models have multiple screw
holes on the cabinet leg. Be sure not to use the
same screw hole as the access cover, and that the
water valve does not interfere with other components
or wires in the compressor compartment, as this may
cause damage.
CONNECT WATER TUBE
3
TO INLET
from the kit with pliers and slide the clamp over
the fill tube assembly, located in the top right
corner of the refrigerator.
free end of the water tube
assembly as far as it will go.
water tube in place.
Fill tube
assembly
14
4
Water tube
3
C
9
hose clamp
Clamp
3
49-60698-4

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Im4led

Tabla de contenido