Twin Star Home 18EF010GAA Manual De Instrucciones Adjunto página 8

OPERATING INSTRUCTIONS CONTROL FUNCTIONS
TO ACCESS CONTROL PANEL - Control panel
can be accessed at upper-right corner of insert by
pushing and lifting up the small door.
POWER - The Power switch supplies power to all
of the functions of the fireplace. This switch must
be in the position for any functions including the
remote to work.
HEATER - Your fireplace consists of a fan forced
wire element type heater. The (ICON HERE)
switch turns the heater ON and OFF. The rotary
switch (THERMOSTAT) controls the thermostat
feature to help regulate your room's temperature
accordingly. As an important safety feature, the
heating element is designed with a delayed
activation sequence. Therefore, when the heater
is turned ON it will take several seconds for the
unit to begin blowing hot air. Subsequently, the
fan blower will continue to run for several
seconds after the heater is switched OFF.
TEMPERATURE - The Temperature control knob
regulates the temperature level of the heater.
The further the knob is rotated clockwise, the
higher the set point temperature.
Model#
18EF010GAA
Model#
23EF010GRA
Model#
28EF010GRA
33EF010GRA
Turning the knob counter-clock-wise will lower
the set point temperature. Use this function to help
regulate the ambient temperature level.
DOWN LIGHT (28EF010GRA & 33EF010GRA
ONLY) - The Down Light switch turns on the down
lights that illuminate inside of the firebox.
FLAME (18EF010GAA)
The Flame control knob adjusts the flame bright-
ness.Turning the knob to the left (counter-
clockwise) dims the lights and flame effect. If the
knob is turned completely to the left (counter-
clock-wise) it will turn the flame effect OFF.
Turning the knob to the right brightens the lights
and flame effect.
FLAME (23EF010GRA, 28EF010GRA &
33EF010GRA)
Each time the flame button is pressed, the intensity
of the flame decreases. There are five brightness
levels you can cycle through including the OFF
setting.
WARNING: During any service of this appliance,
the power to the unit must be turned off. First turn
the main power switch to the "OFF" position. Then
remove the electrical plug from the wall outlet.
Figure 9
Figure 10
INDICATOR LIGHT
Figure 11
INDICATOR LIGHT