General Information; Laser Safety - Bematech Aquila S-3200 Guía De Referencia Rápida

GENERAL INFORMATION

General handling precautions

Do not dispose of the scanner in fire.

Do not put the scanner directly in the sun or by any heat source.

Do not use or store the scanner in a very humid place.

Do not drop the scanner or allow it to collide violently with other objects.

Do not take the scanner apart without authorization.
Radio Notice
Some equipment generates uses and can radiate radio frequency energy. If not installed and used in accordance with the instructions
in this manual, it may cause interference to radio communications. The equipment has been tested and found to comply with the
limits for a Class A computing device pursuant to EN55022 and 47 CFR, Part 2 and Part 15 of the FCC rules. These specifications
are designed to provide reasonable protection against interference when operated in a commercial environment.
Radio and Television Interference
Operation of this equipment in a residential area can cause interference to radio or television reception. This can be determined by
turning the equipment off and on.
The user is encouraged to try to correct the interference by one or more of the following measures:

Reorient the receiving antenna.

Relocate the device with respect to the receiver.

Move the device away from the receiver.

Plug the device into a different outlet so that the device and the receiver are on different branch circuits.
If necessary, the user may consult the manufacturer, authorized dealer, or experienced radio/television technician for additional
suggestions. The user may find the following booklet prepared by the Federal Communications Commission helpful: "How to Identify
and Resolve Radio-TV Interference Problems." This booklet is available from the U.S. Government Printing Office, Washington, DC
20402 U.S.A., Stock No. 004000003454.
For CE-countries
This scanner is in conformity with CE standards. Please note that an approved, CE-marked power supply unit should be used in
order to maintain CE conformance.

Laser Safety

The Advanced Compact Dual-Laser Omnidirectional Vertical Scanner complies with safety standard IEC 60825 for a Class I laser
product. It also complies with CDRH as applicable to a Class IIa laser product. Avoid long term staring into direct laser light.
Radiant Energy
The Dual-Laser Omnidirectional Vertical Scanner uses two low-power visible laser diodes operating at 650nm in an opto-mechanical
scanner resulting in less than 3.9µW radiated power as observed through a 7mm aperture and averaged over 10 seconds.
Do not attempt to remove the protective housing of the scanner, as unscanned laser light with a peak output up to 0.8mW would be
accessible inside.
Laser Light Viewing
The scan window is the only aperture through which laser light may be observed from this product. A failure of the scanner mo tor,
while the laser diode continues to emit a laser beam, may cause emission levels to exceed those for safe operation. The scanner
has safeguards to prevent this occurrence. If, however, a stationary laser beam is emitted, the failing scanner should be disconnected
from its power source immediately.
Adjustments
Do not attempt any adjustments or alteration of this product. Do not remove the protective housing of the scanner. There are no user-
serviceable parts inside.
11