Dynex DX-DTVMFP23 Guia De Instalacion página 18

Insert the concrete wall anchors (Q) into the pilot holes and use a hammer to make
3
sure the anchors are flush with the concrete surface.
Align the wall plate (A) with the anchors, insert the lag bolts (P) through the lag
4
bolt washers (O), then through the holes in the wall plate. Tighten the lag bolts only
until they are firm against the wall plate.
CAUTION: Avoid potential injuries or property damage! DO NOT over-tighten the lag
bolts (P).
Concrete wall
18
Level
www.dynexproducts.com