Replacing Rechargeable Battery; Troubleshooting - MELINERA HG02411 Instrucciones De Montaje, De Uso Y De Seguridad

Foco láser solar
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 72
it should be cleaned and stored in a dry, warm location. Be sure the
switch
is set to the „OFF" position during storage.
9

Replacing rechargeable battery

Set the switch
Remove the solar cell unit
underside of the battery compartment
compartment
Remove the old rechargeable battery and insert a new recharge-
able battery in the battery compartment
(see Fig. B–C).
Then install all components in the reverse order. Be careful not to
damage the cable.

Troubleshooting

Note: This product has delicate electronic components. This means
that if it is placed near an object that transmits radio signals, it could
cause interference. If you notice that the product is malfunctioning, re-
move any sources of interference from the area of the product.
Note: Electrostatic discharges may cause product to malfunction. In
the event of such malfunctions, remove the rechargeable battery
briefly and reinsert it.
Problem
The light will not
switch on although
the product has been
in sunlight all day.
28 GB/IE
to the „OFF" position (see Fig. D).
9
by loosening the 4 screws on the
1
is located inside the solar cell unit
7
Cause
- The product is not
switched on.
. The battery
7
.
1
noting correct polarity
7
Solution
- Switch the product on
(refer to chapter
„Start-up").

Publicidad

Tabla de contenido
loading

Tabla de contenido