Care And Cleaning; Motor Base - Vitamix Total Nutrition Center Manual Del Usuario

Container:
To prepare your new machine for initial use, follow the Normal Cleaning steps below. This will clean the unit, and break-in the motor.
Normal Cleaning:
1.
Fill the container half full with warm water and add a couple drops of liquid dish washing detergent to the container.
2. Snap or push the complete 2-Part lid into locked position.
3.
Select variable speed 1. Turn machine on and slowly increase speed to variable speed 10, then to High.
4. Run the machine on High speed for 30 to 60 seconds.
5. Turn off the machine, and rinse and drain the container.
To Sanitize:
Follow Normal Cleaning instructions above.
1.
Fill the container half full with water and 1 ½ teaspoons of liquid bleach.
2.
3. Snap or push the complete 2-Part lid into locked position.
Select variable speed 1. Turn machine on and slowly increase speed to variable speed 10, then to High.
4.
5. Run the machine on High speed for 30 to 60 seconds.
Turn off the machine, and allow mixture to stand in the container for an additional 1 ½ minutes.
6.
7. Pour bleach mixture out. Allow container to air dry.
8. Do not rinse after sanitizing.
Lid, Lid Plug and Tamper
Separate the lid and lid plug. Wash the parts in warm soapy water. Rinse clean under running water, and dry. Reassemble before use.
IMPORTANT: To ensure continued and effective performance, do not put the container, lid, lid plug or tamper in the dishwasher.

Motor Base

Electrical Shock Hazard.
Disconnect power before cleaning machine.
Failure to follow instructions can cause death or electrical shock.
1. Unplug the power cord.
2.
Wash the outside surface with a damp soft cloth or sponge, which has been rinsed in a mild solution of liquid detergent and warm
water. Do not place the motor base in water.
3. The centering pad can be removed for more thorough cleaning.
4. Thoroughly clean the switches so they work freely. They may become sticky from use. Use a moistened cotton swab to clean the
grooves around the water-shielded switches. Immediately dry any excess water.
5.
Polish with a soft cloth.
C A R E A N D C L E A N I N G
WARNING
7