Publicidad
Idiomas disponibles
Idiomas disponibles
E. Slide aluminum foot over ladder rail as shown in
Figure 13. Position so the rubber foot is in contact
with the floor. Align with closest set of predrilled
holes in rail. Attach using (2) 1/4" bolts and serrated
nuts per side (included).
Again, be sure the attic ladder power arms are fully extended. Trimmed correctly, your attic
ladder should look like Figure 15. Verify that there are no gaps in the section and both feet are
flat on the floor.
FIGURE 14
If the attic ladder looks like Figure 16, then both of the legs are too long and need to be trimmed
further.
If the attic ladder looks like Figure 14, then both of the legs are too short, and the attic ladder is not
safe to use. A new lower section would need to be purchased from the manufacturer.
F. Install weather stripping per instructions provided.
G. To install trim molding leave 3/8" clearance between your door panel at the hinged end and 1/8"
on other 3 sides.
For customer service, call Louisville Ladder at
1–800–666–2811 or e–mail info@louisvilleladder.com
9
Check the length after making your cuts
FIGURE 15
FIGURE 13
FIGURE 16
Publicidad
