Fitting/Removing The Computer; Installing The Magnet Bracket; Installing The Speed Sensor; Installing The Batteries - Mavic WINTECH FS Manual De Instrucciones

3. FITTING/REMOVING THE COMPUTER

3.1 Slide the computer onto the mount from the front until it
locks into place with an audible click.
3.2 To remove the computer, press the button underneath the
mount and slide
the computer out
towards the front of
the bike.
4. INSTALLING THE MAGNET
BRACKET
Place the magnet bracket on a spoke
on the right side of the wheel, about 3
cm from the rim. The magnet must
be turned toward the outside of
the wheel.
Caution: If you are using a
wheel with extra flat spokes,
you need to cut the tabs on the
magnet bracket beforehand.

5. INSTALLING THE SPEED SENSOR

5.1 Insert a wire tie into each
slot designed for this purpose
from the sensor side. The head
of the wire tie must go in its slot
as far as possible.
5.2 Place the sensor on the right
blade of the fork (the sensor
must be pointing forward); close
the fixing collars without tighten-
ing them.
12
2
3.1 3.2
4.1
4.1
5.2
5.3 Adjust the position of the speed sensor so the center of the
magnet is aligned with one of the arrows on the sensor. The
distance between the magnet and the sensor must be between
5 - 10 mm.
5.4 Tighten the wire tires and cut them flush.
IMPORTANT: At this point, your computer is not yet ready
to function. You still need to set the necessary programs,
and then perform the pairing operation of your device.
1
6. INSTALLING THE
BATTERIES
Power supply for the computer: 1 CR2032 battery.
Power supply for the speed sensor: 1 CR2032 battery.
Only use this type of battery.

Installing the batteries:

6.1 Remove the battery cover by turning
it a quarter turn anticlockwise, using
a coin.
6.2 Insert the battery into its recess,
keeping the + side uppermost.
6.3 Refit the battery cover and close it by turning
it a quarter turn clockwise.
5.1
Do not to use excessive force, or you will
damage the unit.
Check the condition of the seal on the battery
cover each time you change the battery. Replace
the battery cover if the seal is damaged.
Always perform the above operations in a dry
place.
5.4
5.3
6.1
6.2