Ferm PDM1045P Traducción Del Manual Original página 5

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 19
Removing
• Place the chuck key (10) into one of the holes
in the chuck (1).
• Open the chuck (1) by turning the chuck key
(10) counterclockwise.
• Remove the drill bit (11) from the chuck (1).
• Close the chuck (1) by turning the chuck key
(10) clockwise.
• Remove the chuck key (10) from the chuck (1).
Setting depth stop
Fig. C
• Insert the depth stop (3) in the hole in the side
handle ring.
• Slide the ruler to the desired depth.
The On/Off switch
Fig. A
• Switch the machine on by pressing the On/Off
switch (5). When you release the On/Off switch
(5) the machine will turn off.
• The rotation-speed can be adjusted by
pressing the On/Off switch (5) harder for
raising the rotation-speed or release pressure
for lowering the rotation-speed.
Lock-on Button
Fig. A
• You can lock the On/Off switch (5) by pressing
the On/Off switch (5) and then pressing the
lock-on button (4).
• To release the switch-lock; shortly press the
On/Off switch (5) again.
Adjusting of the maximum rotation speed
Fig. A
• Adjust the speed by turning the speed
adjustment wheel (6) to the desired maximum
rotation speed.
Switching the direction of rotation
Fig. A
Do not change the direction of rotation
during use.
• Direction of rotation counter-clockwise: shift
left/right rotation switch (7) to "
• Direction of rotation clockwise: shift left/right
rotation switch (7) to "
Function selection switch
Fig. A
• Set the function selection switch (2) to "
• Set the function selection switch (2) to "
Gear selection switch
Fig. A
• If you set the gear selection switch (8) to
• If you set the gear selection switch (8) to
• When the gear selection switch (8) cannot
User tips
Always use the machine with the side handle
firmly anchored in place - you will not only work
with more comfort, you will also work with more
precision.
Drilling and hammer drilling
• For large holes, for instance in very hard
• Hold the machine firmly with 2 hands. Be
".
".
• Do not apply a lot of pressure on the machine,
In order to avoid damage to the machine,
adjusting the function selection switch (2)
shall only be done when machine is not
running
for drilling.
for hammer drilling.
In order to avoid damage to the machine,
adjusting the gear selection switch (8)
shall only be done when machine is not
running.
position "1", the drilling speed can be adjusted
between 0 and 1,000 /min.
position "2", the drilling speed can be adjusted
between 0 and 2,800 /min.
switch easily between "1" and "2", give the
chuck (1) a little spin by using your hands. This
will help the gears fall into the correct position
and makes switching the gears easier.
Caution: drilling bits and hammer drilling
bits can get very hot
concrete, start using a smaller bit for pilot
drilling first , then drill to nominal size.
aware the drill can jam and because of that
machine might suddenly turn (Especially when
drilling deep holes).
let the machine do the work.
"
"
5

Publicidad

Tabla de contenido
loading

Tabla de contenido