Admiral AAV-1 Guía De Uso Y Cuidado página 7

Note
• In wash water temperatures below 65
detergents do not dissolve well or clean well.
STEP 4
Select Signal
End of Cycle Signal
When the cycle is complete, a signal will sound several
times. On select models the End of Cycle Signal
volume is adjustable. To adjust the volume, select any
setting between OFF and LOUD.
STEP 5
Select Cycle
To select a cycle, push the control dial IN and turn it to
the right (clockwise) until the pointer is at the number
of minutes desired for the wash load.
Cottons Cycle
For regular fabrics, select the cycle time and turn the
Wash/Spin Speed dial to Normal/Normal. For fabrics
needing a slower spin speed to reduce wrinkling, turn
the wash/spin speed dial to Normal/Slow.
Delicates Cycle
This cycle provides up to 12 minutes of agitation.
°
F,
Depending on the load, select either the Slow/Slow or
Slow/Normal wash/spin speed.
Stain Cleaner Cycle
Soak Cycle
This cycle provides approximately 30 minutes of
agitation and soaking to help remove stubborn dirt
and stains. For more information see page 7.
STEP
Select Extra Rinse
(style varies by model)
When the switch or knob is in the "On" position, an
additional rinse at the end of the Cottons cycle is
provided to more completely remove laundry additives,
suds, perfumes, etc.
STEP
Pull Control Dial Out to Start
You may stop the washer at any time by simply
pushing the control dial IN. Therefore it is possible to
obtain a non-agitated soak or to shorten, skip or
repeat any part of a cycle. The control dial must be
pushed IN (off position) when you change the setting.
Note
• Do not attempt to turn the control dial
counterclockwise. Damage to the timer will result.
Control features vary by model
(select models)
(select models)
6
(if desired)
7
6