Select Models; Special Features; Liquid Bleach Dispenser; Fingertip Faucet - Admiral AAV-1 Guía De Uso Y Cuidado

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Special Features

Liquid Bleach Dispenser

The dispenser automatically dilutes liquid chlorine
bleach before it reaches your wash load. To use, follow
these steps:
1. Measure liquid chlorine bleach carefully, following
the instructions on the bottle.
2. Add the bleach to the dispenser before adding the
load. Avoid splashing or over-filling the dispenser.
Note
• Never pour undiluted liquid chlorine bleach
directly onto the load or into the wash tub. It is a
powerful chemical and can cause fabric damage,
such as tearing or color loss, if not used properly.
• If you prefer to use color-safe, non-chlorine
bleach, pour it into the wash tub with your
detergent. Do not pour non-chlorine bleach into
the bleach dispenser.
Pour liquid chlorine bleach into
bleach dispenser.

Fingertip Faucet

Provides a flow of water when holding the
switch in the "On" position.

Liquid Dispenser

The dispenser may be used for fabric softener with
most cycles or liquid detergent with the Stain Cleaner
or Soak cycle (select models). The liquid dispenser
should be cleaned before and after each use of liquid
detergent. The dispenser automatically releases the
7

(select models)

liquid at the proper time during the cycle. To use,
follow these steps:
1. Pour a measured amount of desired liquid into
the dispenser to fill line only.
2. If liquid comes below line, add warm water.
If it is necessary to clean the dispenser:
1. Pull the dispenser off of the top of the agitator.
2. Soak for one hour in sink or container in hot water
and dishwashing liquid.
3. Hold hands over top and bottom of dispenser and
shake to loosen buildup.
4. Rinse with clean, hot water.
5. Repeat process if necessary.
6. Replace dispenser on agitator.
Do not use dishwashing liquid inside the washer.
Oversudsing can occur.
Stain Cleaner Cycle
Soak Cycle
(select models)
This cycle eliminates the inconvenience of soaking
stained loads before they are placed in the washer. To
use:
1. Add liquid or granular detergent to the washtub.
2. Add the load.
3. Add liquid detergent only to the Liquid Dispenser
in the top of the agitator.
4. Set the control dial to Start in the Stain
Cleaner/Soak Cycle.
The load will soak for 30 minutes with brief periods of
agitation. The water is then spun out and clean wash
water is added along with the liquid detergent for a
16-minute wash cycle.

Safety Spin

If for any reason you open the washer lid when the
washer is in a spin or extract period, the operation will
immediately stop. This is for your personal safety. If
your washer does not stop, call for service immediately.
When the lid is closed, the operation will automatically
resume.
(select models)

Publicidad

Tabla de contenido
loading

Tabla de contenido