Programming Options; Technical Characteristics - TA HALL 6370 Manual De Instrucciones

Programming Options:

Advance Curve: Allows to select among 4 different curves, 6º, 9º, 12º and
15º. These curves can be altered using a software and a PC or through the
PTA105 terminal.
Activation point of the Advance by TPS:
Select the option 2 (2 red LED blinks).
l
With the engine running, press the accelerator until the point where the
l
advance wants to be activated.
Press the programming button shortly, in this way the wanted point is
l
memorized.
While the option 2 remains selected, each time the button is pressed, the
l
present TPS value is taken as activation point.
Type of TPS:
Selects between a regular 0-5V TPA and a 5-0V reverse one.
CKP outlet signal:
allows to select the type of HALL sensor CKP has. The
possible outlets are: OC (Open Collector), 5V or 12V.
CMP outlet signal:
allows to select the type of HALL sensor CMP has. The
possible outlets are: OC (Open Collector), 5V or 12V.
CMP Activation
: Activates the entry and advance generation at the CMP
outlet´s sensor.
Self-programming:
allows the TAP to program itself with the values it
detects of the vehicle.
Turn on the vehicle.
l
Running on gasoline.
l
Engine regime stable between 2600 and 3000 RPM.
l
Go to the Option 7 (Self-programming), and check the green LED blinks
l
just once. This indicates that everything is ready for self-programming. If it
blinks twice, there is a mistake, check the electric connections.
Short press on the button.
l
The TAP will execute the Self-programming. This process might take
some seconds.
12. Instructions Manual
Emergency
If the TAP should fail, in the wiring harness there is an emergency
connector to reestablish the vehicles original connection.
Remove the protecting cap in the TAP´s lower part
l
Disconnect the cables harness from the TAP, releasing the cramp on the
l
connector.
Connect it to the emergency connector, in this way the engine works with
l
its original connection.

Technical Characteristics

10 ÷ 14,5 VDC
Supply voltage:
l
Shifter´s measures:
l
Height
Depth
Width
Kit´s content
HALL Timing Advance Processor.
l
Wiring for the HALL TAP.
l
Accessories for electrical installation.
l
Mounting Instructions.
l
13. Instructions Manual
105 mm
35 mm
65 mm