Publicidad
CONTENU DE L'EMBALLAGE
NOM DES PIÈCES
Nettoyeur haute pression
Assemblage de la gâchette
Lance de pulvérisation
Cuve à savon
Poignée
Vert - Embout à petit angle (25°)
Blanc - Embout à large angle (40° )
Outil de nettoyage à pointe de pulvérisa-
tion
Vis
Manuel d'utilisation
Guide rapide de démarrage
FIGURE
This Quick Start Guide is not a substitute for reading the operator's manual. To reduce the risk
Set-up
Installing the wheels
Insert the axle through the wheel.
WARNING:
of injury or death, user must read and understand operator's manual before using this product.
Slide the washer over the axle pass the pin hole.
1
washer water intake.
Connect garden hose to pressure
Insert the axle and wheel through the frame. Slide the washer
the wheel assembly.
over the axle and insert the pin through the hole to firmly fasten
1800 PSI / 1.1 GPM
2
Assemble pressure washer gun to spray wand.
Wheel
ELECTRIC PRESSURE WASHER
GPW 1800
USING DETERGENT
Axle
Washer Pin
Put pressure washer detergent in detergent tank.
Install blue or black soap nozzle.
3
Connect desired pressure tip.
Squeeze trigger and wait approx.1 minute for soap.
Installing the gun holder
and push through.
Line up the screw sleeves with the holes in the upper handle
Insert the screw and turn clockwise with a Phillips head
4
Insert high pressure hose into trigger
screwdriver (not included) until the screw is tight.
handle.
SPRAY TIP
SPRAY TIP APPLICATION
Red - Stream tip (0° )
The red 0 degree tip provides a straight line of spray. It provides the highest
5
Connect the high pressure hose to the
0
O
amount of pressure. It is best used for removing hard, stuck-on grime or dirt.
water outlet connector.
The green pressure washer tip provides high versatility with its 25 degree angle tip.
Green - Narrow fan tip (25° )
dirt from surfaces, but is designed to not damage many surfaces. This pressure
Referred to as the washing tip, because it provides adequate pressure to remove
25
O
washer tip is designed for "sweeping" foliage or debris given its wide angle. This tip
6
Turn on water at outlet.
is versatile due to its wide area of cleaning and strong pressure application.
White - Wide fan tip (40° )
Installing the upper handle
The white 40 degree tip, referred to as the "fan" tip creates the widest area of
7
Run water hose for 30 seconds with the
Push and hold the push-pin buttons on the sides of the upper
handle assembly (1) as you slide the handle onto the frame (2).
40
O
or delicate cleaning applications. It is recommended for light cleaning on wood
cleaning with relatively low pressure. This pressure washer tip is best used for light
motor in OFF position. This helps drain air
(1)
decks and other soft or delicate surfaces.
30
S
from the tank and lines.
Black - Soap spray tip
8
Connect power cord to wall outlet
pressure high volume for optimum performance. Soap cannot be applied under
The black soap spray tip, is used for soap application. Soap is applied under low
Extension cord not recommended.
Push-pin
(2)
SOAP
high pressure with this machine.
Turbo Nozzle Tip
9
The nozzle rotates in a zero to 15 degree spray pattern in a circular motion to
Turn on Pressure Washer
IMPORTANT: Ensure water outlet is On
wide, depending on a distance between the tip and the surface being cleaned.
break down tough dirt and grime. The spray pattern can cover area of 4 to 8 inches
before turning power On to avoid damage
to the pump.
NOTE:
AUTO ON/OFF SWITCH: This Pressure washer is equipped
Do Not Return to Store
Missing parts, accessories or need a service center?
with an Auto Start/Stop feature.
Call : 1-888-909-6757
To operate: Turn the power switch to the On (I) position.
www.GreenWorksTools.com
Pump will pressurize and shut down immediately.
Once the trigger of the gun is depressed the unit will turn on.
Rev:02
Unit will shut off and be in standby mode when trigger is
released.
10
QTÉ
1
1
1
1
1
1
1
1
2
1
1
Publicidad
