Lighting; Usb Port - General Motors ARIV MELD Manual De Instrucciones

d. Lighting
Front Light
Turn the front light off and on with the power button located on top of the light.
The front light is powered by the bike battery and will work for 2 additional hours
should you drain your battery while using the bike (EU bike only). The headlight
will not work unless the bike is powered on.
Rear Seat Post Light
Plug the USB cord (provided) into the port at the side of the seat post under the
saddle to charge. The first red led will flash while charging. Charging time is
about 2.5 hours if the battery is fully discharged. Flashing will stop when the
charging is complete.
Run time on a full charge is;
• 5 led mode – 10 hours
• 3 led mode – 15 hours
When the battery is low, the USB port cover will be blue in colour. The light will work for about an hour before turning off.
To turn the lights off and on and change the mode from 5 leds to 3 leds – press on the second led light.
Turn Signals (North America only)
There is an on/off button on the inside edge of each handlebar grip. Press
it once and the light will flash to indicate the direction in which you wish to
turn. The light will stop flashing after 15 seconds. The signal can also be
turned off by pressing the on/off button.
The turn signal lights are powered by a "AAA" battery in each grip. To
change the batteries, loosen the set screws at either end of the grip.
Remove the grip from the handlebar. Pull the light section of the grip away
from the grip. Change the battery and then re-install.
e. USB Port
There is a USB port located under the front headlight. The bike must be on for it to provide power. Lift the rubber flap and
plug in your device. It will charge your smartphone while you ride.
9
EN