Replacing The Lamp; Closing The Door - AEG SD14FS Manual De Instrucciones

18 www.aeg.com
Problem
Some specific surfaces in‐
side the fridge compartment
are warmer at some times.
Temperature setting LEDs
flash at the same time.
If the advice does not lead to
the desired result, call the
nearest Authorized Service
Centre.

8.2 Replacing the lamp

The appliance is equipped with a longlife
LED interior light.
Only service is allowed to replace the
lighting device. Contact your Authorised
Service Centre.
Possible cause
There is no cold air circula‐
tion in the appliance.
An error has occurred in
measuring the temperature.

8.3 Closing the door

1. Clean the door gaskets.
2. If necessary, adjust the door. Refer
to installation instructions.
3. If necessary, replace the defective
door gaskets. Contact the Authorised
Service Centre.
Solution
Make sure that there is cold
air circulation in the appli‐
ance. Refer to "Hints and
Tips" chapter.
This is a normal state.
Contact the nearest Author‐
ised Service Centre. The
cooling system will continue
to keep food products cold,
but temperature adjustment
will not be possible.