Optional Accessories; Technical Data - Desoutter E-LIT BOX V2 Manual De Instrucciones

English
Original instructions.
© Copyright 2017, Ets Georges Renault 44818
St Herblain, FR
All rights reserved. Any unauthorized use
or copying of the contents or part thereof
is prohibited. This applies in particular to
trademarks, model denominations, part numbers
and drawings. Use only authorized parts. Any
damage or malfunction caused by the use of
unauthorised parts is not covered by Warranty or
Product Liability.
STATEMENT OF USE
This product is intended to drive, monitor and
control the following Desoutter range of tools.
- ELC screwdrivers
- DWT torque wrenches
- DWTA torque and angle wrenches
No other use is permitted.
For professional use only.

TECHNICAL DATA

Input voltage
9-30 V
The external power supply
shall provide:
- the input voltage filtered
- the circuit with a non-
Input current 0.25 A - 0.3 A
Weight 550 g
IP rating 54*
Using Temperature Min.
Max.
Wireless protocol 802.15.4 standard
Default serial communication:
Baud rate 19,200 Baud
Parity none
Data length 8
Stop bit 1
* All connectors and cap must be properly
connected.
● Contact your local Desoutter
representative for more information.
11/2017
and regulated (SELV
stands for safety extra
low voltage).
dangerous energy level.
0°C
45°C
9 / 40

OPTIONAL ACCESSORIES

- E-LIT BOX V2 power supply
100-240 VAC to 24 VDC power supply with
interchangeable AC plug
Part number: 6159270530
- E-LIT BOX simulator
Reporting box with leds and push buttons
Part number: 6159290490
INSTALLATION
● See page 5.
● Connect the antenna.
● Switch off the 24V power supply
and the PLC before installing the
module.
All dimensions are in mm.
A
WALL MOUNTING
● Secure the module by using 4 screws (not
supplied in the box).
MOUNTING ON DIN RAIL
B
● Mount the module in vertical position, the
connectors being directed to the bottom.
● Clip the module on the rail.
C
E-LIT BOX V2 CONNECTORS
1 24 V power switch
M12 male connector
2 J1
24 V power supply and digital inputs
M12 female connector
3 J2
Digital outputs
USB port.
4
When the USB port is not used, put the
plastic cap instead.
D J1 CONNECTOR
1 24 V Power supply 24 V
2 0 V Power supply 0 V
3 INCOM Common of inputs 1 to 4
4 OUTCOM Common of outputs 1 to 8
5 IN1 On pulse, the tool is locked
6159920990_03