Installation - W&H Osmo Manual Del Usuario

INSTALLATION

Install the osmotic group using the
supplied dowels and screws
Unscrew the cartridge holders.
Remove the cartridges and take off
the wrapping (resin and carbon
block cartridges). Reposition the
cartridges in the holder taking care
of the centring rings, the gaskets
and O-rings.
Tighten all the holders.
Connect the water block group and
one-way valve to the water network
tap.
Insert the tube into the fitting and
tighten with a ring nut.
Connect the tube to the pump's
inlet fitting and tighten with a ring
nut.
Mount the brackets from the
assembling kit on the drain tube.
Pierce the drain tube with a bit Ø
6mm.
Insert the black drain tube from
the back of the osmotic membrane
and tighten with a ring nut.
10
Ø 6mm
A
A
Check that
the filter is
present
A
Pierce
Ø6mm
B C
Gaskets and
O-Rings
B
B
C
C
Osmo