Specification Of Basin Volume; Alarms - POOL MinipH Instrucciones De Uso

2.10. Specification of basin volume

Possible settings : by code, according to the tables below.
Basin volume
from 0 to 1 m 3
from 1 to 2 m 3
from 2 to 3 m 3
3
from 3 to 4 m
from 4 to 5 m 3
from 5 to 6 m 3
from 6 to 7 m 3
from 7 to 8 m 3
from 8 to 9 m 3
from 9 to 10 m 3
Default setting :
1) Make a long press on the right key until the message
2) Press the up or down key x times until the message
3) Press the right key : the flashing code corresponds to the basin volume recorded.
4) Select a code with the up/down keys.
5) Press the right key to validate : the selected code freezes briefly, then the message
6) Press the left key twice to return to the default display.

2.11. Alarms

Flashing
Fault detected
display
Difference of
+ or - 0.5
pH between
measurement
measurement
and the pH
setpoint
Succession
of several
unsuccessful
attempts to
correct the pH
Code Basin volume
from 10 to 15 m
from 15 to 20 m
from 20 to 25 m
from 25 to 30 m
from 30 to 35 m
from 35 to 40 m
from 40 to 45 m
from 45 to 50 m
from 50 to 55 m
from 55 to 60 m
.
Immediate
automatic
action
-
the pH
pH
regulation
stopped
Code
3 from 60 to 70 m
3 from 70 to 80 m
3 from 80 to 90 m
3
from 90 to 100 m
3 from 100 to 110 m
3 from 110 to 120 m
3 from 120 to 130 m
3 from 130 to 140 m
3 from 140 to 150 m
3 from 150 to 160 m
flashes.
flashes.
Checks and remedies
Manually measure the pH with a recent test
kit.
If the value obtained corresponds to the
value displayed :
a) Switch off the electronics box.
b) Pour the pH corrector (acidic if the pH
is too high, or basic if the pH is too
low) into the basin, near the delivery
nozzles, so as to obtain a pH of
around 7.2.
c) Wait 30 minutes.
d) Restart the electronics box.
e) Check that the pH measured by the
electronics box is approximately 7.2.
If the value obtained
correspond to the value displayed :
Perform a pH probe calibration.
- Check that the pH corrector container is
not empty. If the container is empty,
replace it then perform a manual injection
of pH corrector.
- Check the condition of the ballast filter
and the injection connector.
- Carry out a calibration of the pH probe.
Basin volume Code
3
3
3
3
3
3
3
3
3
3
flashes.
does not
Acknowledgment
Automatic
Press
the right key
7