Descargar Imprimir esta página

BOMANN TSG 7404 Instrucciones De Servicio página 64

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 38
Control lamp: lights up, when the water supply
is closed.
6 The control lamps indicate the program selection.
7 The control lamps indicate the start delay selec-
tion. 6h is indicated by 2h and 4h simultaneously.
Starting a program
 The water supply must be opened to maximum
pressure.
 Load the dishwasher basket.
 Fill in the detergent.
 Turn on the appliance.
 Set the required program options.
 Start the operation.
Changing the program
CAUTION:
A program change should be done only a short time
after starting the program. Otherwise, maybe deter-
gent has been dissolved and rinse water drained off.
First press the Start/Pause button to stop the
current rinse program.
 Press the Program selection button for about
3 seconds.
 Select a new program and start the new opera-
tion.
Forgot to add a dish?
WARNING:
Open the door very carefully during operation, there
is a risk of water squirting out.
Dishware can be added any time before detergent
has been dissolved or rinse water drained off.
 Press the Start/Pause button to stop the opera-
tion. Once the spray arms have stopped, you can
fully open the appliance door.
 Add forgotten dishware.
 Press the Start/Pause button, the operation will
continue after approx. 10 seconds.
At the end of program
CAUTION:
Allow the appliance to cool down a bit after the pro-
gram has ended, before you open it. This avoids that
steam escapes that causing long-term damages to
your furniture.
At the end of the rinse cycle will sound a series of
signals; then the unit goes into standby mode.
If no operation takes place within 15 minutes, the
device switches off automatically - energy-saving!
Turn off
 Turn off the appliance.
 Close the water supply, if necessary!
 Remove the dishes after cooling (see "Unloading
the dishwasher").
 Leave the appliance door slightly open until the
next rinse cycle to avoid odors.
 If the appliance is not in use for an extended peri-
od, disconnect it from the power supply!
Unloading the dishwasher
CAUTION:
Let the dishware cool down for about 15 minutes
before unloading. Hot dishes are sensitive to knocks.
NOTE:
At the end of program there could be still water drops
inside the appliance.
Open the appliance door and pull out the basket.
64

Publicidad

loading