Bosch PLR 15 Manual Original página 20

OBJ_BUCH-1900-002.book Page 20 Friday, March 28, 2014 3:24 PM
20 | English
Switching On and Off
To switch on the measuring tool, push the On/Off switch 1 toward the
rear. When switching on the measuring tool, the laser beam is switched
on. The LASER indicator flashes on the display.
To switch off the measuring tool, push the On/Off switch 1 toward the
front.
Measuring Procedure
After the measuring tool is switched on, continuous measurement takes
place. Aim the laser beam at the target surface. The current measuring
value g is displayed in the bottom line of the display (see figure A). During
continuous measurement, the measuring tool can be moved relative to
the target, whereby the current measuring value g is updated approx. eve-
ry 0.5 seconds in the bottom line of the display (see figure B). In this man-
ner, as an example, you can move a certain distance away from a wall,
while the actual distance can always be read. The LASER indicator flashes
on the display.
The rear edge of the measuring tool is preset as the reference plane for the
measurement.
For a wall to wall measurement, as an example, position the measuring
tool with its rear edge against the initial wall.
 Do not point the laser beam at persons or animals and do not look
into the laser beam yourself, not even from a large distance.
"HOLD" Function (see figure B)
Press the "HOLD" button 2 to stop the measur-
ing procedure. The laser beam is switched off
and the HOLD indication appears on the dis-
play. The current measuring value is still dis-
played in the bottom line of the display, but is
no longer continuously updated.
Press the "HOLD" button 2 once more to
switch the laser on again. The LASER indicator
flashes on the display. The previous measuring
value is displayed in the top line. The continu-
ously updated/current measuring value is dis-
played in the bottom line.
1 609 92A 0JX | (28.3.14) Bosch Power Tools