JOCCA 6160 Manual De Instrucciones página 9

16-E
allow people not accustomed to this kind of appliances,
handicapped people or children to use this item.
-Before connecting the appliance to the mains, check that the
cable and plug are in perfect conditions. Also check that the
voltage indicated on the appliance is valid for your electrical
installation.
-If you detect that the power supply cable, the plug or the adaptor
are damaged or have fallen into water or any other liquid, do not
use the appliance, replace the cable, the plug, or the adaptor. Go
directly to the authorised JOCCA technical service where they will
replace it correctly for you.
-Never leave the appliance cable hanging or in contact with hot
parts.
-Do not immerse the appliance in water or any other liquid.
-Do not pull the cable to unplug the appliance from the mains,
always pull from the plug.
-If your appliance has been dropped or fallen into water or any
other liquid do not use it or try to repair it. Take it to the JOCCA
technical service.
-Do not use the appliance with wet hands.
-Do not move the appliance when it is in use.
-Use the appliance on a flat surface.
-Do not leave the appliance on top of or near a hot electrical or
gas burner.
-Completely unroll the power cable to avoid overheating.
-Please do not roll the cable around the appliance.
-This pedaller is designed to be pedalled sitting down. As it is not
stable please do not mount on top or stand on it.
-The machine can only be used by one person at a time.
-Remember that when you are using this machine you are doing
exercise and therefore appropriate clothing and footwear must be
used. Do not use clothing that might get caught up and obstruct
the machine mechanism.
-If abnormal symptoms are felt, such as dizziness, nausea or
pains in the chest... stop training immediately and visit your
doctor.
-To avoid any possible strains or injury, before using the machine
always carry out stretching exercises to warm up your muscles
properly.
REMEMBER THAT PERSONS WITH HEALTH PROBLEMS
MUST CONSULT THEIR DOCTOR BEFORE STARTING AN
EXERCISE PROGRAMME.
ASSEMBLY
-Before starting with the assembly, ensure that the switch is off
and that the machine is disconnected from the mains electricity
supply.
-Screw down the machine small front base with the key provided,
and do the same with the big rear base. 6 screws are provided for
this purpose.
-In order to avoid any assembly errors, stickers are in place on
the bases and other parts of the machine. Please ensure that "A"
coincides with "A", and "B" with "B".
-Then put in place the pedals or the handle bars on the machine,
depending upon the part of the body you wish to exercise.
-In order to fix the pedals make sure that the R (right) and L (left)
stickers coincide. It will be seen that the letters on the accessories
(pedals and handle bars) coincide with the stickers on the
machine.
-Please remember that in order to fix the "R" (right) pedal or
handle bar and the L (left) pedal or handle bar these must be
turned clockwise, and to remove them they must be turned
anticlockwise. The spanner provided must be used for this.
BEFORE USING THE MACHINE PLEASE CHECK THAT ALL
THE SCREWS ARE TIGHTENED DOWN.
E-17