Tools Required; Connections To Be Made - Metra 99-6514B Manual Del Usuario

• Provides accessory (12-volt 10-amp)
• Retains R.A.P.
(Retained Accessory Power)
• Provides NAV outputs (Parking Brake,
Reverse, Mute, and V.S.S.)
• Prewired ASWC harness included
(ASWC sold separately)
INtErFACE COmpONENtS
• A) Interface • B) 16-pin harness with stripped leads
• C) 18-pin harness to 22-pin Chrysler harness with stripped leads
A B

tOOlS rEquIrED

• Cutting Tool • Crimping Tool • Tape
• Connectors (example: butt-connectors, bell caps, etc...)
99-6514 Interface
• High level speaker input
• Micro "B" USB updatable
• Retains balance and fade
• Ability to add aftermarket Back-up
cam and additional video input
• Retains OE screen
C
99-6514B

Connections to be made

From the 16-pin harness:
• Connect the red wires to the
ignition wire of the
aftermarket radio
• Connect the Orange/White
wire to the illumination wire
of the aftermarket radio. If the
aftermarket radio has does not
have an illumination wire, tape off
the Orange/White wire.
• Connect the Blue/White wire to
the radio's amp turn on wire
• Connect the Brown wire to the
mute wire of the aftermarket radio.
If the aftermarket radio does not
have a Mute wire, tape up the
Brown wire.
• Connect the light Green wire
to the parking brake wire of the
aftermarket navigation radio.
4
• Connect the Blue/pink wire to the
VSS or speed sense wire of the
aftermarket navigation radio.
• Connect the Green/purple wire to
the reverse wire of the aftermarket
navigation radio.
• Plug the 16-pin harness into the
interface
NOTE: The following wires on
the 16-pin harness are not
used in this application.
Purple
Purple/Black
Green
Green/Black
White
White/Black
Gray
Gray/Black