To Replace System Components If Needed - Honeywell YTH6320 Serie Guía De Instalación Del Sistema

Sistema inalámbrico redlink, con módulo de interfaz del equipo
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Replacing system components
Thermostat
To replace a thermostat, install batteries and follow the procedures on
pages 5-6 to link it to the wireless network. If necessary, modify settings as
needed (see tables on pages 9-11).
Remote control & outdoor sensor
To replace a remote control or outdoor air sensor, install batteries and
follow the procedures on pages 5-7 to link it to the wireless network.
Equipment interface module (EIM)
After installing a new EIM, you must re-set the thermostat and remote
control to communicate with the new EIM, as described below.
At the thermostat:
1 Press and hold the
2 Press
twice to display Function 39 (wireless setup).
BACK
3 Press
to change Function 39 setting to 0 (disconnect from old EIM).
4 Follow the procedures on pages 5-6 to link to new EIM.
At the remote control:
1 Press and hold the blank space (or arrow if present) in the lower right
corner of the screen until the display changes (about 3 seconds).
2 Press
REMOVE
3 Follow the procedure on page 7 to link to new EIM.
and
FAN
, then
to disconnect from old EIM.
YES
Español: vea la página 20 • Français : voir la page 39
buttons for 3 seconds.
Press and hold for
about 3 seconds
15

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido