Schwaiger DSR 1004 CW Manual De Usuario página 34

060615_k7 200 ENG sat_shw
Menu Guide
Channel Search
27
DIGITAL SATELLITE RECEIVER
6/15/06 6:01 AM ˘
7. 0V/12V
8. Tone Burst
9. Longitude
10. Latitude
11. Press the BLUE button to set Drive(Fine Drive or Normal Drive) to
run the motor.
- Fine Drive/Normal Drive : To move the motor,
press LEFT/RIGHT( / ) button.
- Go to zero : To move the zero position, press OK(
- East Limit : To set the east limit by current position, press OK(
- West Limit : To set the west limit by current position, press OK(
- Clear Limit : To clear the stored limit value, press OK(
Note: After the Degree, Longitude and Latitude is enterted accurately.
the DiSEqC Motor will automatically move to the satellite's position.
G After selecting all that is necessary, press RED button to scan the satellite list.
Pop up widow will be displayed.
G Select ON or OFF according to your Network.
G Select All or FTA Search Type.
G Press OK( ) button and searching will start.
` 27 mac-4 HP LaserJet 5100 Series
: Depending on the user's antenna switch box.
You can choose either 0V/12V.
: Depending on the user's antenna switch box.
("off", "SAT A" or "SAT B")
: Press the NUMERIC buttons and enter the Longitude.
When the OK( ) button is pressed. It can be toggled
East/West.
: Press the NUMERIC button and enter the Latitude.
When the OK( ) button is pressed, it can be toggled
North/South.
T
) button.
) button.
) button.
) button.