Control Lock - GE MONOGRAM ZET1 Manual Del Propietário

Using the clock, kitchen timer and control lock.
Make sure the clock is set to the
correct time of day.
The Kitchen Timer is in hours and
minutes.
The Kitchen Timer does not control
oven operations. The maximum
setting on the Kitchen Timer is 9
hours and 59 minutes.
Press and hold for 3 seconds.
49-80784
To Set the Clock
The clock must be set to the correct time of day
for the automatic oven timing functions to work
properly. The time of day cannot be changed
during a timed baking or self-cleaning cycle.
To Set the Kitchen Timer
Touch the TIMER pad.
Touch the number pads until the amount
of time you want shows in the display. For
example, to set 2 hours and 45 minutes,
touch 2, 4 and 5 in that order. If you
make a mistake touch the TIMER pad
and begin again.
Touch the START pad.
To Reset the Kitchen Timer
If the display is still showing the time remaining,
you may change it by touching the TIMER pad,
then touch the number pads until the time you
want appears in the display.
To Cancel the Kitchen Timer
Touch the TIMER pad twice.

Control Lock

Your control will allow you to lock out the touch
pads so they cannot be activated when touched.
To lock/unlock the controls:
Touch and hold the 9 and 0 pads for 3
seconds.
The oven display will show "Oven controls
locked" for several seconds, then "Locked."
Touch the CLOCK pad.
Touch the number pads.
Touch the START pad.
After touching the START pad, SET disappears;
this tells you the time is counting down, although
the display does not change until one minute
has passed. Seconds will not be shown in the
display until the last minute is counting down.
When the Kitchen Timer reaches :00, the
control will beep 3 times followed by one
beep every 6 seconds until the TIMER
pad is touched.
The 6-second tone can be canceled by following
the steps in the Special features of your oven
control section under Tones at the End of a
Timed Cycle.
If the remaining time is not in the display (clock,
delay start or cooking time are in the display),
recall the remaining time by touching the
TIMER pad and then touching the number pads
to enter the new time you want.
To unlock the control, touch and hold the
9 and 0 pads for 3 seconds.
The CONTROL LOCK mode affects all touch
pads. No touch pads will work when this
feature is activated.
GEAppliances.com
11