Philips InteGrade LED Guía De Instalación Rápida página 2

Important
Please take the time to read this installation guide before you install this Philips LED product and driver.
The guide contains important information regarding installation and operation.
Warranty
Warranty only applies when the appropriate Philips LED driver and Philips cabling (as described in this guide and leaflets) are used.
Please visit our website www.philips.com/ledrefrigeration or contact your local sales office for more information.
Warnings
• The installation guide does not supersede local or (inter)national regulations for electrical installations.
• This Philips LED product and LED driver must be installed by a professional electrician in accordance with the applicable and
appropriate electrical codes and the instructions provided by Philips.
• Please note that the driver should be built into an enclosure (Tcase max. 80 °C / 176 °F).
• This Philips LED product is designed to be connected to a circuit from a class 2 power source (Philips Xitanium LED power driver)
with energy-limited supply.
• This is a 24 V DC product.
• Do not connect this LED product to mains voltages.
• To allow for variance in the installation, it is not recommended to load the power driver beyond 90% of its rated maximum power.
The energy consumption of the engine is a nominal value, with an estimated 20% deviation.
• Before installation, maintenance or cleaning, always first switch off or disconnect the power and follow the appropriate safety procedures.
• Before removing any lens covers or fluorescent lamps, always first switch off or disconnect the mains power to the lighting system.
• Take care not to damage the existing (heating) wiring if the LED product is installed in a freezer.
• Do not use tape to fix this InteGrade LED product or LED profile in position; please use the appropriate mounting clips.
• Please note that the colors of the wires in existing designs, such as refrigeration systems or cabinets, may differ. The position of the
(original) ballast may also differ.
• Do not make sharp bends with electrical wires.
• Due to the variety of designs and brands in which the Philips LED products can be installed, you may need to use customized mounting
accessories to fit the specific design you are using. If you require further support, please contact your local Philips sales organization.
• To prevent unwanted tripping caused by the inrush current of the LED driver, an MCB (mini circuit breaker) / fuse (slow blow) of
at least 6 A must be installed.
• Philips advises using a zero-crossing/switching solid-state relay to reduce the inrush current peak.
• This product is designed for damp and dry locations only.
Cleaning
• Use a damp cloth and a mild cleaning agent. Do not wipe the LED product with a dirty or very wet dishcloth or towel
because they may leave residue that can damage the LED product.
• Do not use abrasive cleaners, scouring pads, bleach or cleaners containing chlorine because they can scratch and damage
the LED product.
Maximum allowed number of drivers per circuit breaker
LED Power driver 80W - 24V
LED Power driver 20W - 24V
• These values are indicative and shall not take the place of local and (inter) national regulations for electrical installations.
• This table only applies to the specified Philips driver.
• The data in this table are indicative, the installer must take into account external factors. External factors beyond the control of Philips Lighting (eg cable length,
mix of products on the circuit breaker, ...)
• Note that the maximum number of drivers is given for a situation in which this all be connected at the same time, for example via a wall switch.
2
12nc B10
929000653906 ≤2
929000654006 ≤8
B16 C6 C10
≤5 ≤3 ≤6
≤15 ≤8 ≤16
C16 Imax (A) Period (ms)
≤10 100 0,15
≤28 50 0,18