Flush Mounted Installation - 2X8 Framing - Dimplex BLF34 El Manual Del Propietario

Fireplace Installation
the circuit on which the fireplace is
to be installed has the power cut off
at the service panel until installation
is complete.
3. Lift fireplace and insert into
opening (Figure 8).
4. Use the supplied bubble level
to level the fireplace within the
framing, adjust as required.
5. Drive four supplied mount-
ing screws through the four
mounting holes located in
each corner of the fireplace
chassis, into wall studs (Figure
8).
6. Refer to Front Glass Installa-
tion section, page 14 for final
installation procedures.
Flush Mounted Installation
- 2x8 Framing
CAUTION: Two people may
be required for various steps
of this procedure.
1. Prepare a wall with a framed
opening of 33 in. (83.8 cm)
wide x 18 ½ in. (47 cm) high
(Figure 9).
!
NOTE: The sizing has allowed
for ¼ in. (6.4 mm) around the
fireplace insert for ease of instal-
lation. This fireplace does not
require any additional venting.
14
!
NOTE: It is recommended
that the bottom of the unit not be
mounted higher than 40 in.
(102 cm) from the ground to main-
tain an optimized viewing angle of
the flame.
2. Choose your method of sup-
plying power to the unit:
• Plug in (you may run the
power cord out of the framed
wall opening to an existing
outlet or install an outlet on
a nearby wall stud within the
wall).
• Hard wire the fireplace (recom-
mended). Follow the hard wir-
ing instructions on page 9.
WARNING: Do not attempt
to wire your own new outlets or
circuits. To reduce the risk of fire,
electric shock or injury to persons,
always use a licensed electrician.
WARNING: Ensure that the On/
Off Switch is set to the Off position
(refer to Operation section) and that
the circuit on which the fireplace is
to be installed has the power cut off
at the service panel until installation
is complete.
3. Lift fireplace and insert into
opening. The fireplace's
mounting trim should be flush
www.dimplex.com