Publicidad
4. FEATURES
5. CHARGING
IMPORTANT! CHARGE THE WORK
LIGHT IMMEDIATELY AFTER
PURCHASE, AFTER EACH USE, AND AT
LEAST EVERY 6 MONTHS.
Failure to do this will reduce the battery's
capacity and may void the warranty.
5.1 Before charging, make sure the work light
is turned off.
5.2 Remove the connection cover on the back
of the light, below the red Power button.
Insert the end of the AC charger cable
into the input jack on the back of the work
light. Attach the appropriate plug adaptor
6. OPERATING INSTRUCTIONS
USING THE WORK LIGHT
IMPORTANT: Charge the internal battery
before use. (Make sure the work light is
powered off before charging.)
1. Direct the lens away from your eyes
before turning the light on.
2. Press
button once to turn on at low
power.
Press
button twice for medium power.
Press
button three times to turn on
at high power.
Press
button again to shut off the light.
3. Rotate the work light for more precise
positioning.
7. MAINTENANCE INSTRUCTIONS
7.1 After use and before performing
maintenance, unplug and disconnect the
work light.
7.2 Use a dry cloth to wipe any dirt or oil from
the charger, cords and case.
1
2
3
4 5
6
1. Foam-covered handle
2. SMD LEDs (72)
3. Ball joint for swivel and tilt
4. Charging status LEDs
5.
Power button
6. Charging input jack
7. USB output port
Not shown:
8. 100-240V AC wall charger
with plug adaptors
7
PLUG A
to the charger. Plug the AC charger into a
live AC outlet.
5.3 The green charging status LEDs will flash,
to indicate charging has begun.
5.4 Charging will take approximately 4.5
hours. When the battery has charged fully,
all three LEDs will show steady green.
5.5 When fully charged, unplug the charger
from the AC outlet, and then from the work
light. The work light is now ready for use.
5.6 Recharge the work light after use, and at
least every 6 months.
4. Recharge the work light after use, and
at least every 6 months.
USING THE USB PORT
The USB port provides up to 2.1A at 5V DC.
1. Charge the internal battery before use.
2. Connect your charging cable to the
USB port and the device's input port.
3. Turn on the USB device.
4. When finished using the USB port,
disconnect the USB device.
5. Recharge the work light.
7.3 Ensure that all of the work light's
components are in place and in good
working condition.
7.4 Any servicing should be performed by
qualified service personnel.
• 3 •
PLUG C
PLUG G
PLUG I
Publicidad
