Resetting To The Factory Default Settings; Accessing The Axis Q7404 From The Internet; Further Information - Axis Q7404 Guia De Instalacion

Page 18

Resetting to the factory default settings

This will reset all parameters in all four video channels (including all four IP addresses) to the
factory default settings:
1. Disconnect the power from the AXIS Q7404.
2. Press and hold the Control button (see page 4) and reconnect power.
3. Keep the Control button pressed until the four Status indicators turn amber (this may take up
to 15 seconds).
4. Release the Control button. When the four Status indicators display green (which can take up
to 1 minute) the process is complete and the video encoder has been reset.
5. Re-assign the IP addresses, using one of the methods described in this document.
To reset an individual video channel to the original factory default settings, use the button provided
in that video channel's web interface. For more information, please see the online help or the User's
Manual.

Accessing the AXIS Q7404 from the Internet

Once installed, your AXIS Q7404 is accessible on your local network (LAN). To access the video
encoder from the Internet, network routers must be configured to allow incoming traffic, which is
usually done on a specific port.
• HTTP port (default port 80) for viewing and configuration
• RTSP port (default port 554) for viewing H.264 video streams
Please refer to the documentation for your router for further instructions. For more information on
this and other topics, visit the Axis Support Web at www.axis.com/techsup

Further information

The User's Manual is available from the Axis Web site at www.axis.com or from the AXIS Network
Video Product CD supplied with this product.
Tip!
Visit www.axis.com/techsup to check if there is updated firmware available for your AXIS
Q7404. To see the currently installed firmware version, see the About web page in the
product's Setup tools.
AXIS Q7404 Installation Guide