Care & Cleaning - Sage BPB620 Guía Rápida

Care & Cleaning
Unplug the power cord from the power outlet after
use for safety reasons.
Tumbler cups and lids
To keep your cups and lids clean, avoid allowing
food residue to dry on them. Follow these steps
as soon as possible after use:
• Rinse most of the residue off the blades,
cup and lid.
• Hand wash in warm, soapy water using a mild
liquid detergent and non-abrasive sponge.
Motor base
To clean the motor base, wipe with a soft, damp
cloth then dry thoroughly. Wipe any excess food
particles from the power cord.
Cleaning agents
Do not use abrasive scouring pads or cleansers
on either the motor base or the cups, as they may
scratch the surface. Use only warm soap water
with a soft cloth.
Pressurisation
The cups may be rinsed by adding cold water,
attaching blades, and either blending or shaking
by hand for 10 seconds.
IMPORTANT: There is a risk of pressurisation from
hot water and / or detergent.
When rinsing by attaching blades and blending /
shaking, never add hot or even warm water,
as the steam produced can create dangerous
pressurisation.
Do not add detergent, as the foam produced
will expand and may cause pressurisation.
Dishwasher
The cups, lids and blade assembly may be
washed in the dishwasher on the top shelf only.
Stubborn food stains and odours
Strong smelling foods such cumin and coriander,
and some vegetables such as carrots may leave
an odour or stain the blades, cup or lid.
To remove, pour warm soapy water and fill to the
MAX mark. Set aside to soak for 5 minutes. Then
wash with a mild detergent and warm water, rinse
well and dry thoroughly. Store cups with lids off.
Citrus
Exposure to citrus oil may affect the clarity and
longevity of the Tritan cups. After washing in
detergent, rinse with plain water thoroughly, and
allow to dry immediately. Do not soak if citrus has
been blended.
Storage
Store upright with the cups and blades assembled
and resting on the motor base, or beside it.
Do not store with the cup turned to the ON position,
as this means the motor is engaged and will turn
on immediately when plugged in or switched on
at the wall.
EN
9