Braun Silk-épil 3 Legs & Body 3380 Manual De Instrucciones página 6

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 12
you first shave (see section B) and then
epilate the shorter, regrowing hair a week
later.
Fine, re-growing hair might not grow up
to the skin surface. The regular use of
massage sponges (e.g. after showering)
or exfoliation peelings help to prevent
in-growing hair as the gentle scrubbing
action removes the upper skin layer and
fine hair can get through to the skin
surface.
Description
1 Massaging rollers attachment
2 Epilation head with tweezer element
3 Release buttons
4 On/off switch with incorporated light
5 Socket
6 Special cord set
7 Sensitive area cap
8 Cooling glove
Cooling glove for optional skin
cooling
For the first few epilations or if you have
sensitive skin, you can use the cooling
glove (8), recommended by derma-
tologists to help reduce possible skin
irritation.
• Ensure that the gel pack has been in
the deep freezer (***) for at least
2 hours (for convenience you can store
the gel packs in the freezer).
• Insert the gel pack underneath the
cooling glove's transparent foil. Use
only with glove.
• Put transparent (cool) side of the glove
on your leg.
• Start cooling for approximately
30 seconds, longer if needed.
• Epilate the cooled skin area
immediately as described below.
• Repeat cooling and epilating until
completion.
• While epilating, please ensure your
skin is dry.
Important: Apply cooling glove to the
same area for no longer than 2 minutes.
Keep away from sunlight. Do not use gel
pack when damaged. Dispose of in
household waste. Do not use if you are
hypersensitive, allergic to the cold, or if
your skin suffers from sensory
disturbances, when suffering from
cardiac diseases or arterial circulatory
disorders.
How to epilate
• Your skin must be dry and free from
grease or cream.
• Before use, make sure that the epilation
head (2) is clean.
To turn on the appliance, slide up the on/
off switch (4):
Setting «I»: extra gentle
Setting «II»: extra efficient
When switched on, the switch light illumi-
nates the area to be epilated.
Rub your skin to lift short hairs. For opti-
mal performance, hold the appliance at
a right angle (90°) against your skin and
guide it without pressure against the hair
growth, in the direction of the switch.
The massaging rollers (1) stimulate the
skin before and after the hair is pulled out
for an extra gentle epilation experience.
Leg epilation
Epilate your legs from the lower leg in an
upward direction. When epilating behind
the knee, keep the leg stretched out
straight.
Underarm and bikini line epilation
For this specific application, the sensitive
area cap (7) has been developed as an
optional attachment to be placed on the
epilation head (2).
Please be aware that especially at the
beginning these areas are particularly
7

Publicidad

Tabla de contenido
loading

Tabla de contenido