Troubleshooting - Nevir NVR-7301-TDT7P Manual De Instrucciones

9V power connector. 1.5A, AV Input, Headphones Out, USB 2.0 port, Micro
SD slot, and RF antenna input.
Recording Format: MTS
Frequency range: VHF: 170 ~ 230MHz. UHF: 470 ~ 860MHz.
Bandwidth: 5/6/7/8 MHz
Sound power: 2 x 2W. RMS
Battery capacity: 1200 mAh, 7.4V.
Battery life: 2.0 hours
Charging time: 3.0 hours
GENERAL TROUBLESHOOTING
Check the following points before assuming malfunctions of this unit:
Symptom［COMMON］
No power
No picture.
No sound.
Distorted sound.
No operations can be
performed with the
remote control unit.
No key operation (by the
main unit and/or the
remote control unit)is
effective.
Symptom［TV］
No or poor picture.
No sound or poor sound.
Noise or other interface.
Insert the power plug securely into the power outlet.
Ensure that the equipment is connected property.
Ensure that the equipment is connected properly.
Ensure that the input setting for the TV and stereo system are
correct.
Adjust the master volume to a suitable volume by pressing
VOL+/VOL-button.
Check the batteries are installed with the correct polarities.
The batteries are exhausted: replace them with new ones.
Point remote control at the remote control sensor and operate it again.
Operate the remote control unit at a distance of no more than
6m from the remote control sensor.
Remove the obstacles between the remote control and remote
control sensor.
Disconnect the power plug and then reconnect it (The player
may not be operating properly due to lightning,static electricity or
some other factors.)
Adjust antenna or use an external antenna.
Relocate the unit near a window (if inside a building).
Move units away from this product that causes interference.
Do Auto Tuning again.
Try another channel.
Check the audio settings.
Press MUTE button on remote control to cancel mute function.
Unplug the headphone.
Electronic equipment near the unit is causing interface. Relocate
the unit or move the equipment.
Remedy
Remedy
page -17-