Laerdal AED Trainer 2 Instrucciones De Utilizacion página 6

Copy Approved – Check Revision Before Use
S S E E L L E E C C T T I I N N G G T T R R A A I I N N I I N N G G S S C C E E N N A A R R I I O O S S
You can select a training scenario by using either the optional remote control or via the Trainer's set-up mode. To activate
the setup mode, make sure the electrode pads are not connected, then remove and reinsert the battery. Alternatively, press
and hold down the two blue Up/Down buttons while simultaneously pressing the green On/Off button. When the Trainer
is in set-up mode, the operator display shows the currently selected scenario. To change the scenario selection, use the
Up/Down buttons to select the desired scenario, then press the On/Off button to exit the setup mode. The last scenario
selection is stored in the unit even if the battery is taken out.
Symbol Meaning
(Simulated) shockable rhythm detected by Trainer
(Simulated) non-shockable rhythm detected by Trainer
(Simulated) shockable rhythm detected by Trainer that fulfils CPR first criteria. Trainer recommends CPR
(Simulated) pads problem detected by Trainer
(Simulated) motion problem detected by Trainer
Scenario Scenario description
1
One shock for conversion
2
Four shocks for conversion
3
Troubleshooting pads, one shock needed
for conversion
4
Re-fibrillation after conversion
5
Non-shockable rhythm throughout
Att 1 to PRO-M07-0071.pdf 6
Details
• Shockable rhythm
• One shock for conversion
• Non-shockable rhythm
• Shockable rhythm
• Four shocks needed for conversion
• Non-shockable rhythm
• Poor pad contact, check pads
• Shockable Rhythm
• One shock for conversion
• Non-shockable rhythm
• Shockable rhythm
• One shock for conversion
• Non-shockable rhythm
• Shockable rhythm
• One shock for conversion
• Non-shockable rhythm
6
1/14/2014 11:33:25 AM