Aqua Marina BREEZE BT-19BRP Manual De Instrucciones página 12

1. Clean the area around the cut or puncture using acetone or M.E.K.
2. Draw the outline of the patch using chalk or pencil (do not use ink).
Cut the patch, cover the cut or puncture with approximately 2.5cm (1
inch) overlap on all sides.
3. Apply tape along the outline of the patch. This will prevent the glue
from spreading outside the patch area.
4
4. Apply glue on both the board and patch using a brush or other
applicator. Make sure the glue is spread evenly and completely over the
board and patch. Let the glue dry for 5 minutes.
5. Apply the patch starting on one side and move towards the other side
Be careful not to trap any air bubbles.
6. Use a hairdryer to gently heat the area to ensure a good bond between
the patch and the board.
Use a metal spatula or spoon and firm pressure to ensure a good bond
and to remove any air bubbles.
5
24h
Allow the glue to cure with
the board un-inflated for 24
hours prior to use.
12
6