Configuring The Receiver To Allow A Crestron Control System To Control The Receiver - Sony STR-ZA3100ES Guia De Instalacion

Configuring the receiver to allow a Crestron
Control System to control the receiver
This receiver is certified as Crestron Connected. You can
therefore allow a Crestron Control System to control the
receiver collectively as part of a home automation system by
configuring the receiver as follows.
This operation can only be performed using the buttons and
display panel on the front of the receiver. You will also need
to connect the receiver to a network.
1
Turn on the receiver.
2
Press AMP MENU.
3
Press  /  repeatedly to select [3. NETWORK
SETUP], and then press ENTER.
4
Press  /  repeatedly to select [3.5. CRESTRON
CONNECTED SETUP], and then press ENTER.
5
Input the following items.
– 3.5.2. IP ADDRESS (the controller's IP address)
– 3.5.3. PORT ("41794" is set as the default.)
– 3.5.4. IPID* (the controller's IPID)
* Input the values as hexadecimal numbers.
 Press  /  repeatedly to select each item, and then
press ENTER.
 Press  /  repeatedly to select a digit and press
 /  repeatedly to change the digit.
 Press ENTER to confirm the value.
If you want to re-input the values, press RETURN
and then repeat the steps starting from .
6
Press  /  repeatedly to select [3.5.1. CRESTRON
CONNECTED], and then press ENTER.
7
Press  /  repeatedly to select [ON], and then
press ENTER.
If you have already configured the receiver's network
settings, you can also configure the above settings from a
web browser.
Open a web browser on a computer or mobile device
connected to the same network as the receiver, and then
access the following URL.
http://[receiver's IP address]/
22
US