Maintenance; Oven Window - Maytag Performa PGR4410 Manual Del Usuario

Cleaning Chart Continued
Parts Cleaning Procedure
Oven Interior • Clean frequently using mild abrasive cleaners and a plastic pad.
• Do not use metallic scouring pads because they will scratch the surface.
• When using commercial oven cleaners follow the manufacturer's instructions.
• Wipe up acid spills (tomato or milk based foods) as soon as possible with soap and water. If the spill is not
wiped up, it may discolor the porcelain.
To make cleaning easier, remove the oven door, if desired. (See Maintenance section, below.)
Oven Racks • Clean with soapy water.
• Remove stubborn soil with cleansing powder or soap-filled scouring pad. Rinse and dry.
Plastic Finishes • When cool, clean with soap and water, rinse and dry.
- Door handles • Use a glass cleaner and a soft cloth.
- Backguard trim NOTE: Never use oven cleaners, abrasive or caustic liquid or powdered cleansers on plastic finishes. These cleaning agents
- End caps will scratch or mar finish.
NOTE: To prevent staining or discoloration, wipe up fat, grease or acid (tomato, lemon, vinegar, milk, fruit juice,
marinade) immediately with a dry paper towel or cloth.

Maintenance

How to Remove
Range for
Cleaning and
Servicing
Follow these procedures to remove ap-
pliance for cleaning or servicing:
1. Shut off gas supply to appliance.
2. Disconnect electrical supply to appli-
ance, if equipped.
3. Disconnect gas supply tubing to ap-
pliance.
4. Slide range forward to disengage
range from the anti-tip bracket. (See
Installation Instructions for location
of bracket.)
5. Reverse procedure to reinstall. If gas
line has been disconnected, check for
gas leaks after reconnection. NOTE: A
qualified servicer should disconnect
and reconnect the gas supply.
6. To prevent range from accidentally
tipping, range must be secured to the
floor by sliding rear leveling leg into
the anti-tip bracket.
9
Oven Door
CAUTIONS:
• Do not place excessive weight on or
stand on an open oven door. This
could cause the range to tip over,
break the door, or injure the user.
• Do not attempt to open or close
door or operate oven until door is
properly replaced.
• Never place fingers between hinge
and front oven frame. Hinge arms
are spring mounted. If accidentally
hit, the hinge will slam shut against
oven frame and could injure your
fingers.
To remove:
1. When cool, open the
oven door to the
first stop position
(opened about four
inches).
2. Grasp door at each side. Do not use the
door handle to lift door.
3. Lift up evenly until door clears hinge
arms.
To replace:
1. Grasp door at each side.
2. Align slots in the door with the hinge
arms on the range.
3. Slide the door down onto the hinge
arms until the door is completely
seated on the hinges. Push down on
the top corners of the door to com-
pletely seat door on hinges. Door
should not appear crooked.
NOTE: The oven door on a new range
may feel "spongy" when it is closed.
This is normal and will decrease with
use.

Oven Window

To protect the oven door
window:
1. Do not hit the glass with pots, pans,
furniture, toys, or other objects.
2. Do not close the oven door until the
oven racks are in place.
Scratching, hitting, jarring or stressing
the glass may weaken its structure caus-
ing an increased risk of breakage at a later
date.