Ryobi EAG950RB Manual De Utilización página 8

GB
FR DE ES
electrical wiring or objects that can cause kickback.
ADDITIONAL SAFETY WARNINGS SPECIFIC FOR
GRINDING OPERATIONS
a. Check that the speed marked on the grinding
wheel is equal to or greater than the rated speed
of the tool.
b. Ensure that the dimensions of the grinding wheel
are compatible with the tool and that the wheel ¿ ts
the spindle.
c. Grinding wheels must be stored in a dry place.
d. Do not store objects on top of the grinding wheels.
e. Grinding wheels must not be used for any
operation other than grinding.
f. Inspect the grinding wheel before use to ensure
that it is not chipped or cracked. Chips or cracks
can cause the wheels to shatter, resulting in
possible serious injury.
g. Ensure that the grinding wheel is correctly mounted
and tightened before use and run the tool at no-
load speed for 30 seconds in a safe position. Stop
immediately if there is considerable vibration or if
other defects are detected. If this condition occurs,
check the tool to determine the cause.
h. Do not use separate reducing bushings or adapters
to adapt large hole grinding wheels.
i. Check that the workpiece is properly supported.
j. Ensure that sparks resulting from use do not create
a hazard e.g. do not hit people, or ignite À ammable
substances.
k. Always use protective safety glasses and ear
protectors.
l. Use other personal protective equipment such as
gloves, apron and helmet when necessary.
m. Never place the tool on the À oor or other surfaces
while it is running. Grinding wheels continue to
rotate after the tool is switched off. Never touch
the wheel or place it on the À oor or other surfaces
while it is rotating.
n. The À ange and clamp nut must have same outer
diameter.
o. Use the tool only for approved applications. Never
use coolants or water or use the tool as a ¿ xed
tool.
p. Grip the tool securely with both hands while
operating.
SYMBOL
Safety Alert
V Volts
Hz Hertz
IT NL PT DK SE FI NO RU PL CZ
English
W
n º
n
min ¹
SPECIFICATIONS
Model
Wheel diameter
Thickness
Grinding
wheel
Cutting-
off wheel
(optional)
Diamond
cutting wheel
(optional)
Voltage
Input
3
HU RO LV LT EE
Alternating Current
Watts
No-load speed
Rated speed
Revolutions or reciprocations per minute
CE Conformity
Double insulation
Wear ear protection
Wear eye protection
Please read the instructions carefully before
starting the product.
Waste electrical products should not be
disposed of with household waste. Please
recycle where facilities exist. Check with your
Local Authority or retailer for recycling advice.
Recycle raw materials instead of disposing
of as waste. The machine, accessories and
packaging should be sorted for environmental-
friendly recycling.
EAG950RS /
EAG950RSD
115 mm (4.5 in)
6 mm
3 mm
2 mm
230 V - 240 V
50 Hz
950 W
HR SI SK GR TR
EAG950RB /
EAG950RBD
125 mm (5 in)
6 mm
3 mm
2 mm
230 V - 240 V
50 Hz
950 W