Velleman VRC801D Manual De Instrucciones página 3

4. Learning Function
The learning function is used to supplement the pre-programmed code list. The standard code list may provide most of the
functions needed, but you can add a small number of functions for your remote control or add a new code from a remote
control not mentioned in the code list. Prepare the other remote control from which you will copy the code.
a. Learning a Command
• Press the device key you would like to learn a
command to.
• Hold the SET key pressed for 3 seconds.
• Select LEARNING using the
or the
press OK.
• Select LEARN KEY using the
and press OK. The LCD will display SELECT KEY.
• Select the target key you want to learn the
command (in this example: power) to. The LCD will
display WAITING.
• Point the IR sensor of the VRC801D towards the IR
sensor of the other remote control (max. distance of
5cm).
• Hold the original key (in this example: power) on the
other remote control pressed until the LCD of the
VRC801D reads SUCCESS. Repeat the 3 steps
above if the LCD displays FAILED or to learn
another command.
Remark: - When transferring multiple commands to the same target button, the VRC801D will only save the last programmed
command.
- All functions are transferable except for SHOW VIEW, MACRO, SET, LEARN and ALL OFF.
- This remote control accepts up to 100 codes for a total of 8 devices. However, it may not accept some codes.
b. Deleting a Learned Command of a Device
• Press the device key you would like to delete a
command from.
• Hold the SET key pressed for 3 seconds.
• Select LEARNING using the
or the
press OK.
• Select DELETE KEY using the
press OK. The LCD will display SELECT KEY.
• Press the key you would like to delete. SURE DELET
will appear on the LCD. Press OK to confirm.
SUCCESS will be displayed.
• Repeat the step above for each key you would like to
delete. Press a device key to exit the delete mode.
c. Deleting All Learned Commands of a Device
Use this function to delete all the commands of a device
instead of deleting all the commands one by one.
• Press the device key you would like to delete the
commands from.
• Hold the SET key pressed for 3 seconds.
• Select LEARNING using the
or the
press OK.
• Select DELETE DEV using the
press OK. The LCD will display SELECT DEV.
• Select the device you would like to delete using the
corresponding device key. Press OK.
• SURE DELET appears on the LCD. Press OK to
confirm.
• Repeat the two steps above if you would like to delete the commands from another device.
• Press EXIT to quit.
Remark: - It will take about 3 minutes to delete all the commands in one device. If the commands are not numerous, we
suggest deleting the commands one by one.
VRC801D
button and
or the button
button and
or the button and
button and
or the button and
- 3 - VELLEMAN