Short Manual; Inserting The Batteries - Solarc e-GO! Manual De Instrucciones

There are 3 different versions of e.GO!:
FUN (1 polycrystalline solar module, battery case for 2 or 4 AA batteries NiMH/NiCd)
MASTER (double polycrystalline solar module, battery case for 2 or 4 AA batteries NiMH/NiCd)
PROFESSIONAL (double monocrystalline solar module - approx. 10% higher efficiency-, battery case for 1 to 2 Li-Ion
batteries or alternatively 2 or 4 AA batteries NiMH/NiCd)
e.GO! FUN (left) and e.GO! MASTER (right), respectively with mains adapter 4 V / 1 A / 4 W, master cable (output Nokia) with
3 adapter plugs (example of an accessory kit)
e.GO! PROFESSIONAL with mains adapter 5 V / 1.7 A / 8 W, master cable (output Nokia) with 3 adapter plugs, UNI adapter
cable with 2 adapter plugs, rubber protection, Li-Ionen battery (accessory kit example); on the right without rubber protection

Short manual

1. Inserting the batteries

First put
batteries
against the AA batteries (max. 4 piece)
contacts, then
push down.
Note: use only batteries in accordance with Tab.1 (see below); note the correct polarity; do not use faulty or consumed
batteries, insert only batteries with the same charge condition, only rechargeable batteries!
e.GO! FUN/MASTER
Li-Ion batterie (max. 2 piece)
e.GO! PROFESSIONAL
2
Push gently the
Li-Ion batteries
into the
compartment
against the upper
contacts until they
are properly
embedded.