Solarc e-GO! Manual De Instrucciones página 36

With Li-Ion batteries (only PROFESSIONAL)
Same charging modes, generally max. 1 A of charging current, high precision charging condition display (LED1-3)
(deviation < 20%).
Trickle charge: After a complete charge of the internal batteries a transition into trickle charge (pulse charge) takes place:
LED5 flashes.
Stand-by (with inserted batteries): Stromspar Energy saving mode (stand-by mode) without adapter cable or mains adapter
plugged in. When mains adapter or adapter cable are connected again, transition into active mode (LED display see Tab. 2).
Without inserted batteries (direct operation): Direct operation of an external device by solar power or by another current
source (like the mains adapter) via the DC input socket with an input cable when no batteries are inserted. Please note that
when solely solar powered, output power is directly dependant on solar radiation!
How to reach the highest efficiency? Ideally external devices should be connected for operation or charge when the internal
batteries are full or close to full. These should then be recharged at full sun in switch position 1 (1.3 W) or when additional
double module is connected, in switch position 1 or 2 (2.5 W).
Table 1: Battery types and charge times
Battery type, max. permitted
charging current
NiMH AA, 1A
NiCd AA, 1A
NiMH AAA (via adapters), 1A
RAM AA, 1A**
Li-Ion, e. g. NP120
* for 2 AA or AAA batteries or 1 Li-Ion battery (only PROFESSIONAL); full sun implies at least 1000 W/m² and between 10 – 30°C T
time for 4 AA or AAA batteries (or 2 Li-Ion batteries)
** to be used under specific conditions, please see „Tips and notes".
Table 2: Charging condition display (LED1-3)
Battery-charging condition
0%
< 20%
20 ... < 50%
50 ... < 80%
80 ... 100%
6. Install / configure / remove solar modules
Pull first the middle part (hinge safeguard) out as shown below, then remove lid solar module laterally and then remove base
solar module on the opposite direction.
Charging time with
Typical capacity
mains adapter*
1000 - 2400 mAh 1,5 – 5 hrs.
500 - 1000 mAh 1 – 2 hrs.
600 - 1000 mAh 1 – 2 hrs.
1500 - 2000 mAh 4 - 8 hrs.
1700 - 2000 mAh
Stand-by (flashes slowly)
LED1 LED2
-- --
flash --
-- flash
-- --
flash flash
Charging time solar*
(PROFESSIONAL /
MASTER)
2 – 6 hrs.
1 – 2,5 hrs.
1 – 2,5 hrs.
4 - 8 hrs.
2,5 hrs. 4 hrs.
Active operation (blinks)
LED3 LED1
-- --
-- flash
-- shines
flash shines
flash shines
4
Charging time solar*
(FUN)
4 – 12 hrs.
2 – 5 hrs.
2 – 5 hrs.
8 - 12 hrs.
--
. Approx. Double charging
Ambient
LED2 LED3
-- --
-- --
flash --
shines flash
shines shines