Adjustment Instructions - Kobalt KMS 0724B-03 Manual De Instrucciones

ADJUSTMENT INSTRUCTIONS

The miter saw is properly set and adjusted prior to shipping. The adjustments were made at
the factory and normally do not require re-adjustment.
If, in the course of use, adjustments are required, please follow the directions below.
WARNING
• Battery tools are always in operating condition. Therefore, always remove the battery pack
from the tool before making any adjustments or installing accessories, failure to do could
result in accidental starting causing serious injury.
6. Squaring the Blade to the Fence
a. Remove the battery pack from the tool.
b. Lower the saw arm all the way and engage
the arm-lock pin (AC) to hold the saw arm in
"DOWN" position.
c. Set the bevel and miter angles to 0°.
d. Place the heel of a combination square (not
included) against the blade (O) and the rule of
the square against the fixed fence (T).
NOTE: Be sure to rest the square against the body
of the blade, and not against the teeth of the blade.
e. If the blade is not 90° to the fence, adjustments
are needed。
f. Lift the miter-control lever (P) to unlock the miter
table (L).
g. Hold the miter-control lever to rotate the miter
table until the miter-angle indicator (N) is at
approximately left 30° position on the miter
scale (M).
h. Loosen the three screws that hold the miter
scale in place.
i. Lift the miter-control lever to rotate the miter
table to the 0° position on the miter scale or
until the detent engages in the miter-scale
detent plate.
j. Adjust the miter angle until the blade is flush
with the square.
k. Press the miter-control lever down to lock the
turn table.
l. Tighten the two visible screws that secure the miter scale.
m. Lift the miter-control lever to rotate the miter table until the pointer is at approximately left
30° position on the miter scale.
n. Tighten the remaining screw to secure the miter scale detent plate.
NOTE: If the saw has not been used recently, verify that the blade is square to the fence, and
readjust if necessary.
6a
T
combination
square
6b
15
P
O
L
N M